Address:ZHENLI AVE HEDONG TIANJIN CHINA

Particulate Matter PM1.0, PM2.5, PM10 measurements using PMS5003 sensor connected with ESP8266 board. Sample frequency: 10 minutes. Outdoor environment.

Particulate Matter PM1.0, PM2.5, PM10 measurements using PMS5003 sensor connected with ESP8266 board. Sample frequency: 10 minutes. Indoor environment.

ESP8266 with PMS5003 Sensor

Amateur air pollution monitoring station in Skierniewice, Poland. Air pollution monitoring channel updates every 30 minutes with PM10, PM2,5 and PM1 readings from LookO2, a Plantower PMS5003 based sensor. Moving averages and computed AQI available.

Ever Green Bioenergy Co. Start from 1/12/2016 AM 10:00

Reads a PMS5003 air quality sensor with an ESP32. Written in C code using ESP IDF and VSCode. Using Matlab analysis and React to send an email alert. Reads an AHT20 and displays humidity and temperature.

Homemade **PM2.5*&*PM10** monitoring system using 2 Plantower PMS5003 and 1 Winsen ZH03B low-cost infrared laser sensors. >>> >>> >>> >>> >>> Jul-21 :: Added 1 Winsen MH-Z19B CO2 monitoring sensor module.

Collect environment data of dining room using ESP32.

This is the measurement of air quality by using PMS5003 sensor and Arduino Uno+ESP8233. Measure at A building of SUT. Developed by: Assoc. Prof. Dr. Kongpol Areerak, Dr. Jakkrit Pakdeeto, PEMC research group, SUT (THAILAND)

Air monitor - PMS5003

PMS5003 air quality data

Airbox data to g0v

Sensor used: PMS7003, Interval: 10min, Procedure: wakeup, wait 30sec, take 15 measures, build average, store, sleep

Air check system (CO2-K30 \ Dust-PMS5003)