Weighing data and temperature // Waage und Temperatur

Völker 1-3

Log Temperature and Humidity using Raspberry

Projeto de automação do consumo de água de uma residência

data from Raspberry Pi BME280 sensor project on https://github.com/jrmckenzie/myPiWeather

Raspberry BCM2711-CPU's temperature monitor. Data reading from the /sys/class/thermal_zone file. The RasPi pin GPIO4 connected an Dallas DS18b20 sensor. Field-2 present the room temperature. Channel update every two minutes.

Wat in het vat zit ..... De temperatuur in mijn watervat door een Raspberry Pi gemeten met digitale DS18B20 sensoren op twee verschillende hoogtes.

Aquest canal és pel control d'humitat i temperatura d'un eixam d'abelles mitjançant el sensor DHT11 .

Monitoring of a solar installation with 24V 50W panel, LS1024B PWM controller, 3S10P 33Ah 18650 battery. Used Raspberry Pi3 to decode controller data and ESP8266 module to communicate with ThingSpeak

Temperature / Humidity and Light status for the basement

Monitoring Lora Metadata

Relevé capteur sensé_Hat

Uses Raspberry Pi with Dallas DS18B20 sensors and BMP180 for pressure. Uses udp comms to Wemos D1 mini for switching relays for pump and pond heater. Monitors Koi pond temperature and shack (with water pipes in loft) sending email and ThingTweet update

Private weather station at Rolan Mountain, Lennestadt. Elevation: 299m above sea level. Measurements: Temperature, humidity, soon: barometric pressure. Measuring interval: 15 seconds.

Multiple Wemos D1 Minis with Dallas ds18b20 sampling temperatures updating via UDP over local network to Wemos D1 Uno board for tx to Thingspeak. Raspberry Pi triggers D1 when to tx over udp as Wemos has no time clock. Propagator Wemos monitors temper